
When we last left off we managed to get 20 μm, I’m going to try to improve on it.
Spindle Brace

Adding
- Stainless steel sheet metal (5 mm) brace between the spindle and rear column
- Aluminum sheet (4 mm) at the bottom
reduces deflection (at 110 N) from 20 μm to 16 μm.
Column Brace

Adding a 60 x 200 x 5 mm stainless steel plate reduces deflection from 16 μm to 14.3 μm.
Custom Column Plate

Removing the spindle brace, the deflection goes back up to 17.4 μm. Each triangle plate from Misumi is $$$40, and the custom plate replaces three of them. If the custom plates cost less than $$$120, it’ll be a good deal.
Combine Column and Triangle Plate

Goes down slightly to 17.1 μm, and it’ll save $$$80.
Enclosure

The enclosure will
- Keep the noise down
- Contain the mess
People have managed to get their Shapeoko and Nomad machines under 56dB (Carbide3d Forum).
I have four options for the enclosure panels
- Aluminum (3 mm) – $$$106/pc
- Polycarbonate (5 mm) – $$$81/pc
- Powder Coat Steel (2 mm, 8 hole) – $$$72/pc
- Stainless Steel (2 mm) – $$$119
3 and 5 mm panels can be mounted inside the extrusions, everything else has to be bolted on. I’ll need to investigate how that affects noise isolation.